|
|
|
||
|
Symbol text can be angled as shown to the right: In version 2006,the angle can be changed under Tools | Options | View/Display. Then, toSimply double-click a symbol on the schedule and check “Draw Text at Angle” on the Text tab of the Symbol Properties dialog. In version 2008, choose General in the Program Options section of the Tools tab. Choose the Edit tab to change the angle. Then, for the symbol for which the text should be angled, select it and click Draw Text at Angle on the Current Object tab. Text above and in the middle of the symbol will be drawn up from the symbol at a 30, 45, 60, 90, 120, 135, or 150-degree angle. Alternately, if the text is below the symbol it is drawn down at -30,-45, -60, -90, -120, -135, or -150 degrees. Any text greater than 90 degrees is reversed so that it is not upside-down. Note: When the “Draw Text at Angle” selection is active, the following constraints happen automatically:
|
|
|
|